Everyone will be familiar with the sanitary ware toilet seat. The sanitary ware toilet seat is an important part of the toilet. Many people will often encounter damage to the sanitary ware toilet seat during the use of the toilet. At this time, the sanitary ware toilet seat needs to be replaced. How to remove the toilet seat? Today, I will introduce the disassembly method and precautions of the toilet seat.
Before changing the seat, we need to determine the size and model of the toilet, so as not to buy it is not suitable. So how do I change the seat after buying it? We first need to find the screw that fixes the seat and then use a wrench to remove the screw. After removing this decorative hardware, we can remove the old sanitary ware toilet seat. Then clean the lower seat area, and then you can install the new seat. Tighten the screws with a wrench in the same way. Remember to reverse the direction. When replacing the sanitary ware toilet seat, only the fixing bolt at the back of the toilet can be removed for replacement, and the installation can be performed in the opposite direction. Most toilet seats are of any size, just adjust two bolts during installation. But also need to measure the size, the distance of the screw holes, the width, and length of the toilet seat, and then buy a new sanitary ware toilet seat to replace it. Different styles of sanitary ware toilet seats are installed differently. In general, the bottom of the sanitary ware toilet seat is connected to the toilet, and the back is screwed up. As long as you reach down to find the two sides of the toilet, you can unscrew the screws on both sides. The lid is off. It's very simple. You can try it. During the installation process, consumers also need to pay attention to some issues. First, remove the body fixing plate of the smart sanitary ware toilet seat, then fix the fixing plate to the toilet with screws, and then press the smart sanitary ware toilet seat into the slot to press and fix it.
When choosing a smart sanitary ware toilet seat, consumers need to know the size of the toilet to be “paired” before choosing, so as to ensure that no problems occur in the later installation of the smart sanitary ware toilet seat. The toilet seat of different brands still has certain requirements on the size of the toilet, like the distance between the mounting hole on the toilet and the seat. Generally, the distance between them is less than 7 cm; The distance between the mounting holes should be about 15 cm.
Although the sanitary ware toilet seat is small, it is essential in the toilet. You should know through the introduction of the toilet. The structure of the sanitary ware toilet seat is relatively simple and the disassembly steps are very easy. You can teach everyone according to the editor Method to disassemble and replace the sanitary ware toilet seat to avoid affecting the normal use of the toilet due to the damage of the toilet seat. Disassembly method and precautions of a sanitary ware toilet seat.
